UltraGauge Case replacement - self install


The UltraGauge case is made of Polycarbonate (Lexan) and is very durable.
The case is held together by 6 integral interlocking clasps. There are slots on the sides of the case at each clasp. Attempting to open a case, will destroy the clasps. To install a new case, the gauge internal assembly is placed into the back half case. The cable strain relief is slid into the matching area of the back case. The front half case is then placed over the gauge and back half case, and pressure is applied at each of the snap locations until a audible "click" or "snap" is heard.

Only the case and bracket are available. No other UltraGauge parts are available

Add to Cart:

  • Model: UG_CASE2
  • 49 Units in Stock

Your IP Address is:
Copyright © 2024 Ultra-Gauge.com
Support, Manuals, Knowledge Base
International Shipping
Transmission Temperature