CAN Isolation Cable

$5.49

This cable is designed to isolate the vehicle's OBDII connector and only breakout those signals that are defined for CAN. This cable breaks out the following

Male Connector Pin
Female Connector Pin
Signal
4,5 4,5
Vehicle Ground
16 16
+12 Battery
6.14
6,14
Data Signals

Pins that are isolated: 1,2,3,7,8,9,10,11,12,13 & 15

This cable can also be used as a simple extension.
Cable length connector end to connector end: 14.25" or 36cm
Pin 16 is internally fused at the male end.

While this cable can be used on any vehicle which uses the CAN interface, it is primarily for those vehicles which have non-standard implementations of the OBDII, such that vehicle manufacturers have inappropriately used connector pin signals for proprietary uses.

To learn more:
Proprietary OBDII Implementation
Toyota Tacoma ABS knowledge base article.

All vehicles vehicles manufactured for the USA on or after 2008 are federally required to support CAN. However, many vehicles adopted CAN prior to 2008


For those vehicles that experience odd vehicle impairment even after Forcing the protocol, this cable may correct the issues. However, there is a very insignificant chance that the problem is in the vehicle's ECM firmware, in which case this cable will not remedy the impairment.

Add to Cart:

  • Model: CAN Isolation Cable
  • 42 Units in Stock

Your IP Address is: 3.236.86.184
Copyright © 2024 Ultra-Gauge.com
Support, Manuals, Knowledge Base
International Shipping
Transmission Temperature